Table of Contents
Advertisement
Double Check MOD10/MOD10
Do not Send the Check Digit
Note: by setting "do not send the check digit", if the data length except for the 1 character check digit is less than
the minimum barcode reading limit, the barcode reading will be failed. (For example: the scanner set the the
minimum barcode reading length of MSI-Plessey to 4 characters and "do not send check digit", in such
circumstances,the scanner is not able to read the MSI-Plessey with 4 characters. )
Set the Barcode Reading Length
The scanner is only able to read the MSI-Plessey with tramsmission content length falls in the limited range, the range is
consisted of the maximum value and minimum value in units of character, the MSI-Plessey exceeds the range can not be
read or transmitted.
Read the barcode of "Set the Minimum Length Limit" to adjust the minimum length limit
Read the barcode of "Set the Maximum Length Limit" to adjust the maximum length limit
Set the Minimum Length Limit
Note： the maximum length limit of any 1D barcode must not exceed 255, if the maximum length is shorter than the
minimum length, then the scanner is only able to read the barcodes with the minimum length and the the
maximum length; if the maximum length equals to the minimum length, then the scanner is only able to read the
barcode with such length.
78
No Check
Single Check MOD10
Double Check MOD10/MOD11
Send the Check Digit
Set the Maximum Length Limit
【Start Setup】
【Exit Setup】
Advertisement
Table of Contents
