Plessey; Restore The Default Value; Allow To Read Plessey Or Not; Codeid Setup - Newland NLS-HR15XX-30 User Manual

Nls-hr15 series corded 1d barcode scanner

Table of Contents

【Start Setup】

Plessey

By reading the barcode, the parameter setup of Plessey will be restored to the factory default state.

Allow to Read Plessey

Note: the scanner will become unable to read Plessey by reading the setup barcode "Prohibit Reading Plessey", thus, if

the scanner is unable to read the Plessey, please try to read the setuo barcode "allow to read Plessey".

To activate the setup function by reading "CodeID setup", then read the hexadcimal value inaccordance with the character

which will be set to the CodeID.

Example: Set the CodeID ofPlesseyto "p" (the hexadcimal value is 0x70).

1. Read the "Start Setup" barcode.

2. Read the "CodeID Setup" barcode.

3. Read the numeric barcode "7", "0" (see the appendix—numeric barcode)

4. Read the "Save" barcode.(see the appendix—numeric barcode)

5. Read the "Exit Setup" barcode.

Plessey barcode data does not compulsively include the check digit, if check digit exists, then it is the last character.

Check digit is calculated according to all the datas, for checking if the data is correct or not.



Set "No Check", the scanner will transmit all the barcode data



Set "Check but do not Send Check digit", the scanner will check according to the last bit, if successful, all the data

except for the check digit will be transmitted, if failed, then the scanner will indicate "barcode reading failed"

【Exit Setup】

Restore the Default Setup Value of Plessey

Code ID Setup

Prohibit Reading Plessey

Table of Contents