Set Length Range For Code 128 - Newland HR3260-CS User Manual

Set Length Range for Code 128

The scanner can be configured to only decode Code 128 barcodes with lengths that fall between
(inclusive) the minimum and maximum lengths. To accomplish it, you need to set the minimum and
maximum lengths.
【Set the Minimum Length (Default: 1)】
55
Maximum length of a 1D barcode should not exceed 127 bytes. If minimum length is
set to be greater than maximum length, the scanner only decodes Code 128 barcodes
with either the minimum or maximum length. If minimum length is same as maximum
length, only Code 128 barcodes with that length are to be decoded.
Set the scanner to decode Code 128 barcodes containing between 8 and 12
characters:
1. Scan the Enter Setup barcode.
2. Scan the Set the Minimum Length barcode.
3. Scan the numeric barcode "8". (See the Digit Barcodes in Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Set the Maximum Length barcode.
6. Scan the numeric barcode "1".
7. Scan the numeric barcode "2".
8. Scan the Save barcode.
9. Scan the Exit Setup barcode.
【Set the Maximum Length (Default: 127)】
【Enter Setup】
**【Exit Setup】