Default Setup
Factory Default Setting
All the scanners have the factory default setting, by reading the "Restore to Factory Default" barcode, the scanner will
restore the factory default.
Work Mode Selection
Note:
1.
Wake up the scanner please pressing trigger.
2.
The work mode is a temporarily setting, the device will restore to the previous mode after reboot or power off.
Reading Mode
Manual Scanning Mode
Default setting, the scanner will begin to read the barcode after the trigger is pressed, it will stop after successful reading or
if the trigger is loosed.
16
【Restore to Factory Default】
【Power Off】
【Reboot】
【Test mode】
【Start Setup】
【Exit Setup】