Code 93; Restore The Default Value; Allow To Read Code 93 Or Not - Newland NLS-HR15XX-30 User Manual

Nls-hr15 series corded 1d barcode scanner

Table of Contents

Set the Minimum Length Limit

Note：the maximum length limit of any 1D barcode must not exceed 255, if the maximum length is shorter than the

minimum length, then the scanner is only able to read the barcodes with the minimum length and the the maximum length;

if the maximum length equals to the minimum length, then the scanner is only able to read the barcode with such length.

Example: The steps of set the scanner read the Codabarwith barcode length between 8 to 12 characters.

1. Read the "Start Setup" barcode.

2. Read the barcode of "Set the Minimum Length Limit".

3. Read the numeric barcode "8", (see the appendix—numeric barcode)

4. Read the "Save" barcode.(see the appendix—numeric barcode)

5. Read the barcode of "Set the Maximum Length Limit".

6. Read the numeric barcode "1".

7. Read the numeric barcode "2".

8. Read the "Save" barcode.(see the appendix—numeric barcode)

9. Read the "Exit Setup" barcode.

Code 93

By reading the barcode, the parameter setup of Code 93 will be restored to the factory default state.

Allow to Read Code 93

Note: the scanner will become unable to read Code 93 by reading the setup barcode "Prohibit Reading Code 93", thus, if

the scanner is unable to read the Code 93, please try to read the setuo barcode "allow to read Code 93".

Restore the Default Setup Value of Code 93

Set the Maximum Length Limit

Prohibit Reading Code 93

【Start Setup】

【Exit Setup】

Table of Contents