Set The Barcode Reading Length Limit - Newland NLS-HR15XX-3E User Manual

【Start Setup】
Example: Set the CodeID of Code 128 to ―p‖ (the hexadcimal value is 0x70):
Read the ―Start Setup‖ barcode.
1.
Read the ―CodeID Setup‖ barcode.
2.
Read the numeric barcode ―7‖, ―0‖ (see the appendix—numeric barcode)
3.
Read the ‖Save‖ (see the appendix—numeric barcode)
4.
Read the ―Exit Setup‖ barcode.
5.

Set the Barcode Reading Length Limit

The scanner is only able to read the Code 128 with tramsmission content length falls in the limited range, the range is
consisted of the maximum value and minimum value in units of byte (the maximum value and minimum value also
included), the Code 128 exceeds the range can not be read or transmitted.
 Read the barcode of ―Set the Minimum Length Limit‖ to adjust the minimum length limit
 Read the barcode of ―Set the Maximum Length Limit‖ to adjust the maximum length limit
Set the Minimum Length Limit
Note： the maximum length limit of any 1D barcode must not exceed 255, if the maximum length is shorter than the
minimum length, then the scanner is only able to read the barcodes with the minimum length and the the
maximum length; if the maximum length equals to the minimum length, then the scanner is only able to read the
barcode with such length.
Example: Set the scanner read the Code128 with barcode length between 8 to 12 characters.
Read the ―Stat Setup‖ barcode.
1.
Read the barcode of ―Set the Minimum Length Limit‖.
2.
Read the numeric barcode ―8‖, (see the appendix—numeric barcode)
3.
Read the ‖Save‖ barcode.(see the appendix—numeric barcode)
4.
Read the barcode of ―Set the Maximum Length Limit‖.
5.
Read the numeric barcode ―1‖.
6.
Read the numeric barcode ―2‖.
7.
Read the ‖Save‖ barcode.(see the appendix—numeric barcode)
8.
【Exit Setup】
CodeID Setup
Set the Maximum Length Limit
41