Power Off/Battery Off; Default Settings; Factory Defaults - Newland NLS-HR15-BT User Manual

Enter Setup

Power Off/Battery Off

Power Off Scanner
Note: After scanning the Battery Off barcode, you MUST insert the scanner in a powered cradle to exit battery protection
mode before turning it on.

Default Settings

Factory Defaults

Scanning the Reset Scanner/Reset Cradle barcode can restore the scanner/cradle to the factory defaults.
You may need to reset your scanner/cradle when:
1. Scanner/cradle is not properly configured so that the scanner fails to decode barcodes or to communicate with the
cradle.
2. you forget previous configuration and want to avoid its impact.
3. functions that are rarely used have been enabled for the time being.
Reset Scanner
** Exit Setup
Battery Off
(For Long-term Storage/Shipping)
Reset Cradle
42