Ap-7131 Led Indicators - Motorola AP-7131 Product Reference Manual

b. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the Power Injector Data &
Power Out connector and the AP-7131 GE1/POE port.
c. Ensure the cable length from the Ethernet source to the Power Injector and AP-7131 does
not exceed 100 meters (333 ft). The Power Injector has no On/Off power switch. The
Power Injector receives power as soon as AC power is applied. For more information on
using the Power Injector, see
For standard 48-Volt Power Adapter (Part No. 50-14000-247R) and line cord installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host)
and the AP-7131 GE1/POE port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the AP-7131.
e. Plug the power adapter into an outlet.
15. Verify the behavior of the AP-7131 LED lightpipe. For more information, see
Indicators on page
16. Place the ceiling tile back in its frame and verify it is secure.
The AP-7131 is ready to configure. For information on an AP-7131 default configuration, see
Getting Started on page
System Configuration on page

2.8 AP-7131 LED Indicators

Five LEDs illuminate on the front of the AP-7131 (on top of the AP-7131 housing) for dual radios
models and four illuminate for single radio models. One LED (for above the ceiling installations) is
located on the back of the device.
AP-7131 Power Injector System on page
2-17.
3-1. For specific details on AP-7131 system configurations, see
4-1.
Hardware Installation 2-17
2-7.
AP-7131 LED