Motorola AP-7131 Product Reference Manual page 614

9-8
AP-7131 Access Point Product Reference Guide
Priority
Maximum Message
age
Hello Time
Forward Delay
Forwarding Table
Ageout
6. Click
Configuration can be saved by clicking the
7. Click
the LAN1 or LAN2 screen. Once the Mesh STP Configuration is defined, the access
point's radio can be configured for base and/or client bridge support.
Set the Priority
within the mesh network to defer to this client bridge as the bridge
defining the mesh configuration (commonly referred to as the root).
Motorola recommends assigning a Base Bridge AP with the lowest
bridge priority so it becomes the root in the STP. If a root already
exists, set the Bridge Priorities of new APs accordingly so the root
of the STP doesn't get altered. Each access point starts with a
default bridge priority of 63335.
The Maximum Message age
Age timer. The Message Age timer is used to measure the age of
the received protocol information recorded for a port, and to ensure
the information is discarded when it exceeds the value set for the
Maximum Message age timer.
The Hello Time
sent. This time is equal to 2 seconds (sec) by default, but you can
tune the time to be between 1 and 10 sec. If you drop the hello time
from 2 sec to 1 sec, you double the number of bridge protocol data
units sent/received by each bridge. The 802.1d specification
recommends the Hello Time be set to a value less than half of the
Max Message age value.
The Forward Delay
state. This time is equal to 15 sec by default, but you can tune the
time to be between 4 and 30 sec. The 802.1d specification
recommends the Forward Delay be set to a value greater than half
the Max Message age timeout value.
The Forwarding Table Parameter value defines the length of time
an entry will remain in the a bridge's forwarding table before being
deleted due to lack of activity. If the entry replenishments a
destination generating continuous traffic, this timeout value will
never be invoked. However, if the destination becomes idle, the
timeout value represents the length of time that must be exceeded
before an entry is deleted from the forwarding table.
OK to return to either the LAN1 or LAN2 screen where updates to the Mesh STP
Cancel to discard the changes made to the Mesh STP Configuration and return to
as low as possible for a to force other devices
timer is used with the Message
is the time between each bridge protocol data unit
is the time spent in the listening and learning
Apply button.