Motorola AP-7131 Product Reference Manual page 57

1. Motorola recommends you loop a safety wire—with a diameter of at least 1.01 mm (.04 in.),
but no more than 0.158 mm (.0625 in.) —through the tie post (above the AP-7131's console
connector) and secure the loop.
2. If desired, install and attach a security cable to the AP-7131 lock port.
3. Attach the radio antennas to their correct connectors.
For more information on the antennas available to the AP-7131, see
page 2-4.
4. Cable the AP-7131 using either the AP-7131 Power Injector solution or the AP-7131
approved power supply.
CAUTION Do not supply power to the AP-7131 until the cabling of the unit is
!
For Power Injector installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host)
and the Power Injector Data In connector.
b. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the Power Injector Data &
Power Out connector and the AP-7131 GE1/POE port.
c. Ensure the cable length from the Ethernet source to the Power Injector and AP-7131 does
not exceed 100 meters (333 ft). The Power Injector has no On/Off power switch. The
Power Injector receives power as soon as AC power is applied. For more information on
using the Power Injector, see
For standard 48-Volt Power Adapter (Part No. 50-14000-247R) and line cord installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host)
and the AP-7131 GE1/POE port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the AP-7131.
e. Plug the power adapter into an outlet.
5. Verify the behavior of the AP-7131 LEDs. For more information, see
on page 2-17.
6. Align the bottom of the ceiling T-bar with the back of the AP-7131.
7. Orient the AP-7131 chassis by its length and the length of the ceiling T-bar.
complete.
AP-7131 Power Injector System on page
Hardware Installation
Antenna Options on
2-7.
AP-7131 LED Indicators
2-13