Motorola AP-7131 Product Reference Manual page 643

Configuring Mesh Networking 9-37
Resolution
Yes, mesh nodes also support Automatic Firmware/Configuration updates using DHCP Options. Make
sure you create DHCP reservations for each mesh node and add an appropriate configuration file to
each one of them. If you don't, the base bridge configuration file could get applied on a client bridge
or repeater and you will loose connectivity to that AP.
Mesh Deployment Issue 13 - Why do I lose connectivity when updating
configurations?
When I make a configuration change and apply the changes on a client bridge or repeater, I
momentarily loose connectivity to that AP, why?
Resolution
That is expected behavior, when you make a configuration change on a mesh supported AP, it brings
the radio driver down and then back up again. Consequently, the AP needs to re-establish its mesh
connection after saving the configuration.
Mesh Deployment Issue 14 - Will an existing client bridge see a new base bridge
or repeater?
If I add a new base bridge or repeater to an existing mesh topology, will my current client bridges see
it and connect to it?
Resolution
Yes, all client bridges perform periodic background scanning - both passively (by sniffing the air for
beacons) and actively (by sending Probe Requests). Therefore, a client bridge automatically detects
the presence of a new base bridge or repeater added to the mesh network topology and forms a seam
less connection without affecting current operation.
Mesh Deployment Issue 15 - Can a mesh supported AP react to changing RF
conditions?
If RF conditions change, will a mesh supported AP automatically detect and re-route traffic on its
backup link or look for new links if all current links are exhausted?
Resolution
Yes, all mesh nodes have built in dynamic link switching and auto-recovery mechanisms that ensure
they adapt to changing RF conditions.