Motorola AP-7131 Product Reference Manual page 212

5-74 AP-7131 Access Point Product Reference Guide
The access point Router Table field displays a list of connected routes between an enabled
subnet and the router. These routes can be changed by modifying the IP address and subnet
masks of the enabled subnets.
The information in the access point Router Table is dynamically generated from settings
applied on the
mask (or network mask) and gateway settings are those belonging to each subnet. Displayed
interfaces are those associated with destination IP addresses. To change any of the network
address information within the WAN screen, see
3. From the
LANs (if enabled) to server as the default gateway to forward data packets from one network
to another.
4. To set or view the RIP configuration, click the
Routing Information Protocol (RIP) is an interior gateway protocol that specifies how routers
exchange routing-table information. The Router screen also allows the administrator to
select the type of RIP and the type of RIP authentication used by the switch. For more
information on configuring RIP, see
5. Use the
The User Defined Routes field allows the administrator to view, add or delete internal static
(dedicated) routes.
a. Click the
b. Highlight an entry and click the
c. Specify the destination IP address, subnet mask, and gateway information for the
internal static route.
d. Select an enabled subnet from the
the table entry. Information in the
65535) used by router protocols to determine the best hop routes.
6. Click the
7. Click Logout
logout before the applet is closed.
WAN screen. The destination for each subnet is its IP address. The subnet
Use Default Gateway
User Defined Routes
Add button to create a new table entry.
Apply button to save the changes.
to securely exit the access point applet. A prompt displays confirming the
Configuring WAN Settings on page
drop-down menu, select the WAN or either of the two
RIP Configuration
Setting the RIP Configuration on page
field to add or delete static routes.
Del (delete) button to remove an entry.
Interface(s) column's drop-down menu to complete
Metric column is a user-defined value (from 1 to
5-16.
button.
5-75.