5. Click Update Settings to save and apply the changes. A confirmation message
appears at the top of the page.
You have completed configuring the threshold options. To reopen the previous page,
click the Go back to Wireless Configuration link.
Figure 40.
Threshold settings
Rate Limiting
Rate Limiting allows you to cap the per client data transfer rates for a specific WLAN.
To enable per station rate limits
1. Go to Configuration > Wireless.
NOTE: If you are using a ZoneFlex 7363/7962/7982 AP, go to Configuration > Radio
2.4G or Configuration > Radio 5G.
2. Select the WLAN that you want to configure from the tabs at the top of the page.
3. Click the Edit Settings button next to Rate Limiting. The Rate Limiting page
appears.
4. Set the maximum Downlink and Uplink rate per station.
5. The table below updates to show the maximum transfer rate per station for each
traffic type.
Configuring the Access Point
Configuring Wireless Settings
79