Configuring Led Control And Motion Detection Sensitivity - Lorex LNC216 SERIES Instruction Manual

iPad® App
• Low Light Sensitivity: Set the camera's sensitivity in low light environments between
Very High (highest), High, and Normal (lowest). Tap Done to return to Video settings.
• Place: Select Outdoor for well lit environments. Select Indoor if you notice strip lines
in the image or if the picture is too dark on the Outdoor video setting. Select Indoor
+ Sunlight if the picture is too bright on the Indoor setting. If you select an indoor
setting, select 60Hz or 50Hz to adjust the camera for the frequency of your indoor
lighting. Tap Done to return to Video settings.
• Preference: Select whether you would like the camera to reduce the image quality
or the frame rate when bandwidth increases or decreases. Select Video Motion to
have the camera maintain the frame rate and reduce image quality when bandwidth
is insufficient. Select Image Quality to have the camera maintain image quality and
reduce frame rate when bandwidth is insufficient. Select Better Quality to have the
camera maintain frame rate and increase quality when bandwidth is sufficient. Select
Best Quality to have the camera maintain the frame rate and increase quality to the
maximum speed of the connection. Tap Done to return to Video settings.
• Time Display on Video: Select ON to enable time stamps on video or OFF to disable
time stamps.
• Video flip: Select ON to flip the camera image vertically and horizontally or select
OFF for the normal orientation. This is useful if the camera has been mounted to a
wall or ceiling upside down.
5. Tap Update to save your settings.
7.4.7 CONFIGURING LED CONTROL AND MOTION DETECTION
SENSITIVITY
Configure the behavior of the camera status LED's. This is useful if you want the camera
to be harder to spot at night. You can also configure the sensitivity for video motion
detection.
To configure LED's and motion detection sensitivity:
1. In Camera List, tap
130
next to the camera.