Configuring the WAP2000 Access Point
Configuring Wireless Settings
STEP 3
STEP 4
Configuring Wireless Settings
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide
To automatically configure the time settings so that the access point obtains the
time from a public time server:
a. Click NTP.
b. Select a time zone from the Time Zone drop-down menu.
c. If you are using the access point in a location that observes daylight saving
time, check the Automatically adjust clock for daylight saving changes
check box.
d. To use a local NTP server, click Enabled. The default is Disabled.
In the NTP Server IP field, enter the IP address of your NTP Server.
Click Save.
This section describes how to configure the wireless settings of the access point:
•
Configuring Basic Settings, page 23
•
Configuring Security, page 25
•
Configuring Connection Control, page 41
•
Configuring Advanced Settings, page 43
•
Configuring VLAN & QoS, page 46
6
22