Configuring Wireless Settings - Cisco WAP200 Administration Manual

Configuring the WAP200 Access Point

Configuring Wireless Settings

STEP 3
STEP 4
Configuring Wireless Settings
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster
To automatically configure the time settings so that the access point obtains the
time from a public time server:
a. Click Automatically.
b. Select a time zone from the Time Zone drop-down menu.
c. If you are using the access point in a location that observes daylight saving
time, check the Automatically adjust clock for daylight saving changes
check box.
d. To use a local NTP server, click Enabled. The default is Disabled.
In the NTP Server IP field, enter the IP address of your NTP Server.
Click Save.
This section describes how to configure the wireless settings of the access point:
• Configuring Basic Settings, page 25
• Configuring Security, page 27
• Configuring Connection Control, page 43
• Configuring Advanced Settings, page 45
• Configuring VLAN & QoS, page 48
6
24