Configuring Power; Configuring Basic Settings - Cisco Aironet 521 Quick Start Manual

a521qsg.fmb Page 13 Monday, March 12, 2007 10:40 AM
D R A F T - C I S C O C O N F I D E N T I A L
You must know your access point's IP address before you can use the
web-based management GUI. If your access point obtained its IP address
from your network's DHCP server, you or your network administrator can
find it by querying the DHCP server using the access point's MAC address.
You can also find the access point's IP address using Cisco's IP Setup Utility
You can download IPSU from Cisco.com.

Configuring Power

After connecting the access point to a power source, its status LED might be
amber, which can indicate that the access point is unable to verify that the
PSE is supplying sufficient power. In such cases, you will need to configure
settings on the access point or the switch to identify your power source.

Configuring Basic Settings

Follow these steps to configure basic settings for the access point using the
GUI Express Setup page.
13
Quick Start Guide Cisco Aironet 521 Access Points