Configuring the WAP2000 Access Point
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide
This chapter describes how to configure your Cisco WAP2000 Wireless-G
Access Point with Power Over Ethernet using the web-based configuration utility.
Configuration is not required if you wish to use the access point right out of the
box with its default settings.
This chapter includes the following sections:
•
Setting Up Your Access Point, page 18
•
Configuring Wireless Settings, page 22
•
Configuring the Access Point's Modes of Operation, page 48
•
Configuring Administration Settings, page 51
•
Verifying Access Point Status, page 61
•
Using Windows Help Menus, page 66
6
17