Changing The Lan Parameters; Wireless Settings; Modifying The Wireless Settings - Cisco FM PONTE-50 Installation And Configuration Manual

Changing the LAN parameters

The LAN Parameters box (below) contains the entry controls for local-
address setting.
NOTE
When the General Mode window is opened for the first time,
the Local IP and Local Netmask LAN parameters will be
factory-set default values.
The information needed is self-explanatory. To enter a parameter, click the
field and type the parameter.
If needed, enter the local primary DNS address in the Dns 1 field, and
enter the local secondary DNS address in the Dns 2 field.
Save the LAN settings by clicking the Save button. Alternatively, clear the
settings by clicking the Reset button.

7.4.2. Wireless settings

Modifying the wireless settings

IMPORTANT
If the Cisco FM Ponte kit was purchased in the USA or
Canada, the Country selection is set to the country of
purchase, and the Country: drop-down will be disabled.
The WIRELESS RADIO window contains controls to change the following
settings:
• The shared network passphrase.
• The national territory in which the wireless network is installed.
• The operational radio frequency and bandwidth settings.
To change the Wireless Settings, do the following steps:
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Page 46 of 132