State Activity - Waters Network Systems GSM2109 Operating Manual

Once the LACP aggregator has been configured, the information can be displayed
through the Aggregator Information screen.
Note: The trunk function does not support GVRP and X-Ring.
5.20

State Activity

Once the LACP aggregator has been configured, you can configure the port state activity.
Port state activity can be set to active or passive.
Active – port automatically sends LACP protocol packets
Passive – port does not automatically send LACP protocol packets and responds
only if it receives LACP protocol packets from the opposite device.
Note: A link having either two active LACP ports or one active port can perform
Waters Network Systems
Figure 5.18 – Port Trunk Aggregator Setting
5.19 - Aggregator Information screen
GSM2109/GSM1009-SFP User's Manual Page 61