Projecting
Check the projection lens attachment ( x page 35), external device connection ( x page 37) and power cord connection ( x page 41),
and then switch on the power ( x page 42) to start projecting. Select the video for projection, and adjust appearance of the projected image.
Selecting the input signal
Select an input signal.
1)
Press the input selection (<RGB1>, <RGB2>,
<DVI-D>, <VIDEO>, <S-VIDEO>, <HDMI>)
buttons on the control panel or the remote
control.
f The image of the signal being input in the selected terminal is
projected.
Attention
f Images may not be projected properly depending on the external device, or the blu-ray disc or DVD disc, to be played back.
Set [PICTURE] → [SYSTEM SELECTOR] ( x page 59) on the menu.
f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from [POSITION] → [ASPECT]
( x page 60) in the menu.
Adjusting the focus, zoom, and shift
If the projected image or the position is not correct though the positioning of the projector and the screen is correctly installed, adjust the focus,
zoom, and shift.
At the projector
1)
Press the <LENS> button on the control panel.
f The setup screen will change each time you press the button.
r Adjustable contents
[FOCUS]
[ZOOM]
[SHIFT]
Using the remote control
1)
Press the lens (<FOCUS>, <ZOOM>, <SHIFT>)
buttons on the remote control.
r Adjustable items
Operation
Press the <FOCUS> button.
Press the <ZOOM> button.
Press the <SHIFT> button.
Note
f The zoom adjustment menu is displayed even when a projection lens without zoom function is attached, but it will not operate.
f Use the fixed-focus lens (ET-DLE055) with the lens position on the home position. ( x page 46)
f The adjustment can be performed faster by pressing and holding asqw for at least three seconds.
f It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
f Only [FOCUS] is shown in yellow so that the displayed menu item can be recognized by color (even when the projector is not focused and
displayed characters are unreadable). (Factory default)
The [FOCUS] color depends on the [OSD DESIGN] ( x page 72) settings in the menu.
Chapter 3 Basic Operation — Projecting
Adjusts focus.
Adjusts zoom.
Adjusts shift.
Item
[FOCUS]
[ZOOM]
[SHIFT]
2)
Select each item and use asqw to adjust it.
2)
Select each item and use asqw to adjust it.
Adjusts focus.
Adjusts zoom.
Adjusts shift.
Details
ENGLISH - 45