Connecting to the projector with a cable
When you use the system with multiple projectors, configure the units as in the following figure. Use a commercial M3 stereo mini jack cable
and connect the other devices to the <REMOTE 1 IN>/<REMOTE 1 OUT> terminals of the projector.
The remote control is effective even in places where an obstacle stands in the light path or where devices are susceptible to outside light.
Attention
f Use a cable that is 15 m (49'2") or shorter, with 2 core shield. The remote control may not operate when the length of the cable exceeds 15
m (49'2") or when the shielding of the cable is inadequate.
24 - ENGLISH
Chapter 1 Preparation — Using the remote control
M3 stereo mini jack cable
(commercially available)
Connect to remote
control wired terminal
Connecting terminals
Connect to the second
projector
Remote