[Clock Phase]; [Off] - Panasonic PT-DW740E Operating Instructions Manual

Note
f When [ASPECT] is set to [THROUGH], [ZOOM] is not displayed.
When [ASPECT] is set to [DEFAULT]
1)
Press as to select [ZOOM].
2)
Press the <ENTER> button.
f The [ZOOM] screen is displayed.
3)
Press as to select [MODE].
4)
Press qw to switch [MODE].
r [MODE]
[INTERNAL]
[FULL]
r [INTERLOCKED]

[OFF]

[ON]
Note
f When [ASPECT] is set to other than [DEFAULT], [MODE] is not displayed.

[CLOCK PHASE]

You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1)
Press as to select [CLOCK PHASE].
2)
Press qw or the <ENTER> button.
f The [CLOCK PHASE] individual adjustment screen is
displayed.
Note
f Optimal value may not be achieved if the output from the input computer is unstable.
f Optimal value may not be achieved when there is a shift in the total dot numbers.
f [CLOCK PHASE] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
f [CLOCK PHASE] cannot be adjusted when a digital signal is input.
f If you press w while the adjustment value is [+31], the value will become [0]. If you press q while the adjustment value is [0], the value will
become [+31].
62 - ENGLISH
Chapter 4 Settings — [POSITION] menu
Enlarges the size within the aspect range set with [SCREEN FORMAT].
Enlarges the size to the entire display area set with [SCREEN FORMAT].
[VERTICAL]
[HORIZONTAL]
[BOTH]
5)
Press as to select [INTERLOCKED].
6)
Press qw to switch [INTERLOCKED].
7)
Press as to select [VERTICAL] or
[HORIZONTAL].
f Select [BOTH] when [ON] is selected.
8)
Press qw to adjust.
Set the [VERTICAL] and [HORIZONTAL] zoom ratio.
Use [BOTH] to set zoom ratio. Horizontal and vertical can be expanded
by units of 1.0 time.
3)
Press qw to adjust.
f Adjustment value will change between 0 and +31. Adjust so that
the amount of interference is at a minimum.