[Standby Mode]; [Schedule]; [Off] - Panasonic PT-DW740E Operating Instructions Manual

Note
f When [ECO] is set, the power consumption and operation sound can be reduced while the lamp life can be increased.

[STANDBY MODE]

Set the power consumption during the standby.
1)
Press as to select [STANDBY MODE].
r [STANDBY MODE]
[NORMAL]
[ECO]
Note
f When set to [ECO], network functions and <SERIAL OUT> terminal are not available during standby. Also, some RS-232C commands are
not available. When set to [NORMAL], network functions and <SERIAL OUT> terminal are available during standby.
f When set to [ECO], display may delay about 10 seconds when the power is turned on, compared to the [NORMAL] setting.

[SCHEDULE]

Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1)
Press as to select [SCHEDULE].
r [SCHEDULE]

[OFF]

[ON]
Note
f When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1)
Press as to select [SCHEDULE].
2)
Press qw to select [ON], and press the
<ENTER> button.
f The [SCHEDULE] screen is displayed.
How to set a program
You can set up to 16 commands to each program.
1)
Press as to select [SCHEDULE].
2)
Press qw to select [ON], and press the
<ENTER> button.
f The [SCHEDULE] screen is displayed.
3)
Press as to select [PROGRAM EDIT].
4)
Press qw to select a program number and
then press the <ENTER> button.
78 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Normally use this setting.
Use this setting to reduce power consumption during standby.
Disables the schedule function.
Enables the schedule function. Refer to "How to assign a program" ( x page 78) or "How to set a
program" ( x page 78) in regard to how to set the schedule.
2)
Press qw to switch [STANDBY MODE].
f The setting will change between [NORMAL] and [ECO] each
time you press the button.
2)
Press qw to switch [SCHEDULE].
f The setting will change between [OFF] and [ON] each time you
press the button.
3)
Select and assign program to each day of
week.
f Press as to select the day of week, and press qw to select a
program number.
f You can set the program from No.1 to No.7. "- - -" indicates that
the program number has not been set yet.
5)
Press as to select a command number and
press the <ENTER> button.
f You can change the page using qw .
6)
Press as to select [TIME], and press the
<ENTER> button.
7)
Press qw to select hour and minute, and press
as or the number (<0> to <9>) buttons to set
a time, and press the <ENTER> button.
8)
Press as to select [COMMAND].