Error Information Page - Panasonic PT-DW740E Operating Instructions Manual

Error information page

When [Error (Detail)] is displayed in the self-diagnosis display of the [Projector status] screen, click it to display the error details.
f The projector may go into the standby status to protect the projector depending on the contents of the error.
r Problem occurrence [FAILED]
Parameter
[MAIN CPU BUS]
[FAN]
[INTAKE AIR TEMPERATURE]
[OPTICS MODULE TEMPERATURE]
[AROUND LAMP TEMPERATURE]
[LAMP1 REMAIN TIME]
[LAMP2 REMAIN TIME]
[LAMP1 STATUS]
[LAMP2 STATUS]
[SHUTTER]
[INTAKE AIR TEMP.SENSOR]
[OPTICS MODULE TEMP.SENSOR]
[AROUND LAMP TEMP.SENSOR]
[BATTERY]
[COLOR WHEEL]
[COVER OPEN]
[FILTER UNIT]
[AIR FILTER]
96 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
There is a problem with the microcomputer circuitry. Consult your dealer.
There is a problem with the fan or the fan drive circuit. Consult your dealer.
The air intake temperature is too high. It may be used in an operating environment where
the temperature is high, such as near a heating appliance.
The temperature inside the projector is high. It may be used in an operating environment
where the temperature is high, such as near a heating appliance.
The temperature around the lamp is high. The air exhaust port may be blocked.
The usage time of the lamp has exceeded the specified time, and it is time to replace the
lamp.
The lamp has failed to turn on. Wait a while until the luminous lamp cools off, and then
turn on the power.
There is a problem with the shutter circuitry. Consult your dealer.
There is a problem with the sensor used to detect intake air temperature. Consult your
dealer.
There is a problem with the sensor used to detect temperature inside the projector.
Consult your dealer.
There is a problem with the sensor used to detect exhaust air temperature. Consult your
dealer.
Battery replacement is required. Consult your dealer.
There is a problem with the color wheel or the color wheel drive circuit. Consult your
dealer.
The lamp unit cover is not attached properly. Check the installation of the lamp unit
cover. ( x page 114)
The air filter unit is not attached. Check the connection of the air filter unit. ( x page 113)
There are too much dust accumulated in the air filter unit.
Turn the <MAIN POWER> switch <OFF> ( x page 43), and clean the air filter.
( x page 112)
[OK]: operating properly
[FAILED]: a problem occurred
[WARNING]: warning
Description