Specifications - Panasonic PT-DW740E Operating Instructions Manual

Specifications

The following table describes the specifications of the projector.
Model No.
Power supply
Power consumption
Panel size
Display method
DLP chips
Number of pixels
Power zoom
Lens
Power focus
Luminous lamp
Light output
Contrast ratio
For video signals
(including S
video)
For RGB signals
For YC C /YP
B R B
signals
Supported
scanning
frequency
For DVI-D signal
For HDMI signal
Color system
Projection screen size
Screen aspect ratio
Projection method
*1 Value for the supplied standard zoom lens. The value varies depending on the lens. Measurement, measuring conditions and method of notation
all comply with ISO21118 international standards.
*2 The size is maximum 200" when ET-DLE055 lens is used.
128 - ENGLISH
Chapter 6 Appendix — Specifications
PT-DW740E
(0.3 W when [STANDBY MODE] is set to [ECO], and 8 W when set to [NORMAL])
0.65" (aspect ratio 16:10)
1 024 000 pixels
(1 280 x 800 dots)
1.8 to 2.5:1
F = 1.7 to 1.9
f = 25.6 mm to 35.7 mm
7 000 lm
2 500:1
(when [CONTRAST MODE] is [HIGH])
Horizontal: 15.75 kHz/15.63 kHz, Vertical: 50 Hz/60 Hz
f 525i (480i)
Horizontal: 15.75 kHz, Vertical: 60 Hz
f 525p (480p)
Horizontal: 31.5 kHz, Vertical: 60 Hz
f 750 (720)/60p
Horizontal: 45 kHz, Vertical: 60 Hz
f 1125 (1035)/60i
Horizontal: 33.75 kHz, Vertical: 60 Hz
P
R f 1125 (1080)/50i
Horizontal: 28.13 kHz, Vertical: 50 Hz
f 1125 (1080)/24sF
Horizontal: 27 kHz, Vertical: 48 Hz
f 1125 (1080)/30p
Horizontal: 33.75 kHz, Vertical: 30 Hz
f 1125 (1080)/50p
Horizontal: 56.25 kHz, Vertical: 50 Hz
f The SYNC/HD and VD terminals do not support 3 value SYNC.
525p (480p), 625p (576p), 750 (720)/60p, 750 (720)/50p,1125 (1080)/60i, 1125 (1080)/50i,
1125 (1080)/24p, 1125 (1080)/24sF, 1125 (1080)/25p, 1125 (1080)/30p, 1125 (1080)/60p, 1125 (1080)/50p
f Displayable resolution: VGA to WUXGA (non-interlaced)
WUXGA signal supports only VESA CVT-RB (Reduced Blanking) signal.
f Dot clock frequency: 25 MHz to 162 MHz
525p (480p), 625p (576p), 750 (720)/60p, 750 (720)/50p, 1125 (1080)/60i, 1125 (1080)/50i,
1125 (1080)/24p, 1125 (1080)/24sF, 1125 (1080)/25p, 1125 (1080)/30p, 1125 (1080)/60p, 1125 (1080)/50p
f Displayable resolution: VGA to WUXGA (non-interlaced)
WUXGA signal supports only VESA CVT-RB (Reduced Blanking) signal.
f Dot clock frequency: 25 MHz to 162 MHz
7 standards (NTSC/NTSC4.43/PAL/PAL-N/PAL-M/SECAM/PAL60)
1.27 m (50") - 15.24 m (600")
16:10
[FRONT/CEILING], [FRONT/FLOOR], [REAR/CEILING], [REAR/FLOOR]
PT-DW740EL
AC 220 V - 240 V 50 Hz/60 Hz
760 W (4.3 A)
1-unit DLP chips, DLP type
Optional
f = 25.6 mm to 35.7 mm
300 W (maximum 310 W) UHM lamp x 2
*1 (ANSI)
Horizontal: 15 kHz to 91 kHz, Vertical: 50 Hz to 85 Hz
PIAS (Panasonic Intelligent Auto Scanning) system
Dot clock frequency
162 MHz or less
f 625i (576i)
Horizontal: 15.63 kHz, Vertical: 50 Hz
f 625p (576p)
Horizontal: 31.25 kHz, Vertical: 50 Hz
f 750 (720)/50p
Horizontal: 37.5 kHz, Vertical: 50 Hz
f 1125 (1080)/60i
Horizontal: 33.75 kHz, Vertical: 60 Hz
f 1125 (1080)/24p
Horizontal: 27 kHz, Vertical: 24 Hz
f 1125 (1080)/25p
Horizontal: 28.13 kHz, Vertical: 25 Hz
f 1125 (1080)/60p
Horizontal: 67.5 kHz, Vertical: 60 Hz
*2
PT-DX810E PT-DX810EL
0.7" (aspect ratio 4:3)
786 432 pixels
(1 024 x 768 dots)
1.8 to 2.5:1
Optional
F = 1.7 to 1.9
8 200 lm *1 (ANSI)
2 000:1
(when [CONTRAST MODE] is [HIGH])
4:3