[Input Resolution]; [Clamp Position]; [Edge Blending] - Panasonic PT-DW740E Operating Instructions Manual

Blanking correction Item
Left side of the screen [LEFT]
Right side of the
[RIGHT]
screen

[INPUT RESOLUTION]

You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1)
Press as to select [INPUT RESOLUTION].
2)
Press the <ENTER> button.
f The [INPUT RESOLUTION] screen is displayed.
Note
f Previously mentioned vertical banding will not occur with all white signal input.
f The image may be disrupted while performing the adjustment, but it is not a malfunction.
f [INPUT RESOLUTION] can be adjusted only when an RGB signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
f Certain signals may not be adjustable.

[CLAMP POSITION]

You can adjust the optimal point when the black part of the image is blunt or it has turned green.
1)
Press as to select [CLAMP POSITION].
r Adjustment details
Status
The black part is blunt.
The black part is green.
Note
f [CLAMP POSITION] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
f Certain signals may not be adjustable.

[EDGE BLENDING]

The edge blending function allows multiple projector images to be seamlessly overlapped by using the inclination of the brightness at the
overlapped area.
1)
Press as to select [EDGE BLENDING].
2)
Press qw to switch [EDGE BLENDING].
f The setting will change between [ON] and [OFF] each time you
press the button.
f To adjust edge blending, proceed to Step 3).
3)
Press the <ENTER> button when [ON] is
selected.
f The [EDGE BLENDING] screen is displayed.
Chapter 4 Settings — [ADVANCED MENU] menu
Operation
The blanking zone
Press w .
moves to the right.
The blanking zone
Press q .
moves to the left.
The blanking zone
Press w .
moves to the right.
The blanking zone
Press q .
moves to the left.
Rough guide for optimal value
The point where bluntness of the black part improves the most
is the optimal value.
The point where the green part becomes black, and the
bluntness improves is the optimal value.
Adjustment
3)
Press as to select [TOTAL DOTS], [DISPLAY
DOTS], [TOTAL LINES], or [DISPLAY LINES],
then press qw to adjust it.
f Values corresponding to the input signal are displayed
automatically for each item. Change the displayed values and
adjust to the optimal image viewing the screen when there is a
vertical banding or missing in the screen.
2)
Press qw to adjust.
4)
Press as to specify the location to be
corrected.
f When joining at top: Set [UPPER] to [ON].
f When joining at bottom: Set [LOWER] to [ON].
f When joining at left: Set [LEFT] to [ON].
f When joining at right: Set [RIGHT] to [ON].
5)
Press qw to switch between [ON] and [OFF].
f To adjust edge blending without displaying the adjustment
marker, proceed to Step 8).
6)
Press as to select [MARKER].
Range
PT-DW740E: 0 to 639
PT-DX810E: 0 to 511
Range
1 - 255
ENGLISH - 65