[Cooling Condition]; [High Altitude Mode]; [Lamp Select]; [Floor Setting] - Panasonic PT-DW740E Operating Instructions Manual

[COOLING CONDITION]

Change the fan control depending on the direction of projection.
Set [COOLING CONDITION] correctly in accordance with the direction of projection referring to the following figure. It may shorten the life of
the lamp if used in incorrect setting.
1)
Press as to select [COOLING CONDITION].
2)
Press the <ENTER> button.
f The [COOLING CONDITION] screen is displayed.

[HIGH ALTITUDE MODE]

Set to [ON] to use the projector at 1 400 m (4 593 ft) to 2 700 m (8 858 ft) elevations.
1)
Press as to select [HIGH ALTITUDE MODE].
2)
Press qw to switch [HIGH ALTITUDE MODE].
f The setting will change between [OFF] and [ON].
r [HIGH ALTITUDE MODE]

[OFF]

[ON]
Note
f The speed of the fan increases and the operation sound becomes louder when set to [ON].

[LAMP SELECT]

Switch between brightness of two lamps and that of single lamp from the two luminous lamps built into the projector body according to the
use condition or purpose. When [SINGLE] is set, the lamp to be turned on is automatically selected based on the cumulative operating time of
lamps.
1)
Press as to select [LAMP SELECT].
r [LAMP SELECT]

[DUAL]

[SINGLE]
[LAMP1]
[LAMP2]
Note
f When [SINGLE], [LAMP1], or [LAMP2] is selected, if the lamp does not light or the cumulative operating time exceeds 2000 hours (when
[LAMP POWER] is set to [NORMAL]), the other lamp will light. When [DUAL] is selected, if either lamp does not light or the cumulative
76 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
[UPWARD SETTING]
30°

[FLOOR SETTING]

30°
[DOWNWARD SETTING]
When using at a place lower than 1 400 m (4 593 ft) above sea level
When using at a high altitude (1 400 m (4 593 ft) or higher and lower than 2 700 m (8 858 ft) above sea
level)
Two lamps will light.
Single lamp will light. (The lamp with shorter cumulative operating time is selected automatically.)
Lamp 1 will light.
Lamp 2 will light.
30°
[CEILING SETTING]
30°
Projection direction
3)
Press as to select a cooling condition.
4)
Press the <ENTER> button.
5)
When the confirmation is displayed, select [OK]
or [CANCEL], and press the <ENTER> button.
3)
When the confirmation is displayed, select [OK]
or [CANCEL], and press the <ENTER> button.
2)
Press qw to switch [LAMP SELECT].
f The setting will change among [DUAL], [SINGLE], [LAMP1] and
[LAMP2] each time you press the button.
3)
Press the <ENTER> button.