[Advanced Menu] Menu; [Digital Cinema Reality]; [Blanking]; [Off] - Panasonic PT-DW740E Operating Instructions Manual

[ADVANCED MENU] menu

Select [ADVANCED MENU] from the main menu, and select the item from the sub-menu.
Refer to "Navigating through the menu" ( x page 51) for the operation of the menu screen.
f After selecting the item, press asqw to adjust.

[DIGITAL CINEMA REALITY]

You can increase the vertical resolution and enhance the picture quality by performing the cinema processing when the PAL (or the SECAM)
576i signal, the NTSC 480i, 1080/50i, and 1080/60i signals are input.
1)
Press as to select [DIGITAL CINEMA
REALITY].
r [DIGITAL CINEMA REALITY]
[AUTO]

[OFF]

[25p FIXED]
[30p FIXED]
Note
f When a signal other than a 2:2 pulled-down signal is set to [25p FIXED] or [30p FIXED] in [DIGITAL CINEMA REALITY], picture quality
deteriorates. (Vertical resolution will degrade.)

[BLANKING]

The blanking width is adjusted when there are noise at the edge of the screen or the image is slightly running out from the screen when an
image from the VCR or other devices are projected.
1)
Press as to select [BLANKING].
2)
Press the <ENTER> button.
f The [BLANKING] adjustment screen is displayed.
r Adjustment details
Blanking correction Item
Top of the screen [UPPER]
Bottom of the screen [LOWER]
64 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
Performs automatic detection and cinema processing. (Factory default)
Unforced cinema processing.
Forced cinema processing (2:2 pulldown) is performed when a 576i or 1080/50i signal is input.
Forced cinema processing (2:2 pulldown) is performed when a 480i or 1080/60i signal is input.
Operation
The blanking zone
Press q .
moves upward.
The blanking zone
Press w .
moves downward.
The blanking zone
Press q .
moves upward.
The blanking zone
Press w .
moves downward.
2)
Press qw to switch [DIGITAL CINEMA
REALITY].
f The setting will change among [AUTO], [OFF] and [25p
FIXED] *1 /[30p FIXED] *2 each time you press the button.
*1 Only during 576i,1080/50i signal input
*2 Only during 480i,1080/60i signal input
3)
Press as to select an adjustment item.
4)
Press qw to adjust the blanking.
Adjustment Range
PT-DW740E: 0 to 399
PT-DX810E: 0 to 383