Table of Contents
Advertisement
Preparing the remote control
Inserting and removing the batteries
(i)
1)
Open the cover. (Fig. 1)
2)
Insert the batteries and close the cover (insert the m side first). (Fig. 2)
f When removing the batteries, perform the steps in reverse order.
When using the multiple projectors
When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using a single remote control, if a unique ID number is assigned to each projector.
When using the projectors by setting the ID numbers, set the ID number of the projector body after initial settings
have been completed. Then, set the ID number of the remote control. For initial settings, refer to "When the initial
setting screen is displayed" (x page 53).
The factory default ID number of the projector (projector body and remote control) is set to [ALL], so you can use
it as it is. Set the ID numbers of the projector body and remote control as necessary.
For details on setting the ID number of the remote control, refer to "Setting ID number of the remote control"
(x page 69).
Note
f Set the ID number of the projector body from the [PROJECTOR SETUP] menu → [PROJECTOR ID].
Connecting the remote control to the projector with a cable
To simultaneously control multiple projectors next to each other with one remote control, connect the remote
control with a commercially available M3 stereo mini jack cable using the <REMOTE 1 输入>/<REMOTE 1 输出>
terminals.
The remote control is effective even in places where an obstacle stands in the light path or where devices are
susceptible to outside light.
Remote control
Connecting to the remote
control wired terminal
Attention
f Use a cable that is 15 m (49'3") or shorter, with 2 core shielded. The remote control may not operate when the length of the cable exceeds
15 m (49'3") or when the shielding of the cable is inadequate.
Chapter 1 Preparation — Preparing the remote control
(ii)
Fig. 1
M3 stereo mini jack cable (commercially available)
Connecting terminals
Connecting to a second projector
Fig. 2
ENGLISH - 27
Advertisement
Table of Contents
