Datalogic™ Magellan © Aux Port Configuration; Ncr Bioptic Aux Port Configuration; Wincor Nixdorf Terminal Default Settings - Honeywell Vuquest 3320g User Manual

Datalogic™ Magellan
Scan the following Plug and Play code to program the scanner for a Datalogic Magellan auxiliary port configuration. This
bar code sets the baud rate to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate Defaults bar code on
first, then scan the programming code above.

NCR Bioptic Aux Port Configuration

Scan the following Plug and Play code to program the scanner for an NCR bioptic scanner auxiliary port configuration. The
communication should be set at 9600bps baud rate, 7 data bit data format, even parity and 1 stop bit. The following prefixes
are programmed for each symbology:
Symbology
UPC-A
UPC-E
EAN-8
EAN-13
Code 39
Note: If you are having unexpected results with this programming code, scan the Activate Defaults bar code on
first, then scan the programming code above.

Wincor Nixdorf Terminal Default Settings

Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf terminal. This bar code sets the baud
rate to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate Defaults bar code on
first, then scan the programming code above.
©
Aux Port Configuration
Datalogic Magellan Bioptic Settings
Prefix
A
E0
FF
F
a
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings
Symbology Prefix
Interleaved 2 of 5 b
Code 128 f
GS1 DataBar r
Omnidirectional
GS1 DataBar r
Expanded
Codabar N
Code 32 a
Pharmaceutical
(PARAF)
page 1-4
page 1-4
page 1-4
2 - 5