Ncr Bioptic Aux Port Configuration; Wincor Nixdorf Terminal Default Settings - Honeywell Voyager 1202G-BF User Manual

NCR Bioptic Aux Port Configuration

Scan the following Plug and Play code to program the scanner for an NCR bioptic scanner auxiliary port configuration. This bar
code sets the baud rate to 9600 bps and the data format to 7 data bits, Even parity, 1 stop bit and Message RTS/CTS with time-
out. The following prefixes are programmed for each symbology:
Note: If you are having unexpected results with this programming code, scan the
page 1-7 first, then scan the programming code above.

Wincor Nixdorf Terminal Default Settings

Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf terminal. This bar code sets the baud rate
to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the
page 1-7 first, then scan the programming code above.
Symbology Prefix
UPC-A A
UPC-E E0
EAN-8 FF
EAN-13 F
Code 39 a
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings
Symbology Prefix
Interleaved 2 of 5 b
Code 128 f
GS1 DataBar r
Omnidirectional
GS1 DataBar r
Expanded
Codabar N
Code 32 a
Pharmaceutical
(PARAF)
Resetting the Custom Defaults
Resetting the Custom Defaults
bar code on
bar code on
2 - 9