Ncr Bioptic Aux Port Configuration; Wincor Nixdorf Terminal Default Settings; Wincor Nixdorf Beetle™ Terminal Default Settings - Honeywell Voyager 1602g User Manual

NCR Bioptic Aux Port Configuration

This interface is only appropriate for an Access Point. Scan the following Plug and Play code to program the scanner for an
NCR bioptic scanner auxiliary port configuration, then power cycle the host. The following prefixes are programmed for
each symbology:
Symbology
UPC-A
UPC-E
EAN-8
EAN-13

Wincor Nixdorf Terminal Default Settings

This interface is only appropriate for an Access Point. Scan the following Plug and Play code to program the scanner for a
Wincor Nixdorf terminal, then power cycle the host. This bar code sets the baud rate to 9600 bps and the data format to 8
data bits, no parity, 1 stop bit.
Wincor Nixdorf Beetle™ Terminal Default Settings
This interface is only appropriate for an Access Point. Scan the following Plug and Play code to program the scanner for a
Wincor Nixdorf Beetle terminal, then power cycle the host. The following prefixes are programmed for each symbology:
Symbology
Aztec Code
Codabar
Code 93
Code 128
Data Matrix
EAN-8
EAN-13
GS1 DataBar
GS1-128
Prefix Symbology
A Interleaved 2 of 5
E0 Code 128
Code 32
Pharmaceutical
(PARAF)
FF Code 39
F
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings
Prefix Symbology
V Interleaved 2 of 5
N MaxiCode
L MicroPDF417
K PDF417
R QR Code
B Straight 2 of 5 IATA
A UPC-A
E UPC-E
P All other bar codes
Wincor Nixdorf Beetle Settings
Prefix
b
f
a
a
Prefix
I
T
S
Q
U
H
A0
C
M
2 - 17