High End Systems TechnoArc User Manual page 26

CHAPTER 2
TechnoArc Setup and Configuration
Terminate the link by installing a 120 ohm, 1/4
watt (minimum) terminator in the fixture's Data
Out (female) cable connector in the last fixture
on each DMX link.
To construct a terminator:
1. Disassemble a male 3-pin or 5-pin XLR
connector.
2. Solder a 120 ohm resistor, minimum of 1/4 watt, between Pin 2 and Pin 3.
3. Reassemble the XLR connector.
14 TechnoArc User Manual
TM