Dsa Brocade Test Results - IBM System x3550 M4 Installation And Service Manual

405-907-000 BRCM:TestLEDs Test Failed
Explanation: A failure was detected while verifying operation of the status LEDs.
Severity: Error
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
User response: Complete the following steps:
1. Check component firmware level and upgrade if necessary. The installed firmware level can be found in the DSA
Diagnostic Event Log within the Firmware/VPD section for this component.
2. Rerun the test.
3. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the
next corrective action.

DSA Brocade test results

The following messages can result when you run the Brocade test.
218-000-000 Brocade:MemoryTest Passed
Explanation: The test passed.
Severity: Event
Serviceable: No
Recoverable: No
Automatically notify Support: No
218-001-000 Brocade:ExternalLoopbackTest Passed
Explanation: The test passed.
Severity: Event
Serviceable: No
Recoverable: No
Automatically notify Support: No
218-002-000 Brocade:SerdesLoopbackTest Passed
Explanation: The test passed.
Severity: Event
Serviceable: No
Recoverable: No
Automatically notify Support: No
405-907-000 • 218-002-000
Appendix C. DSA diagnostic test results
691