IBM System x3550 M4 Installation And Service Manual page 505

806f0413-2582xxxx A PCI PERR has occurred on system [ComputerSystemElementName]. (PCIs)
Explanation: This message is for the use case when an implementation has detected a PCI PERR.
May also be shown as 806f04132582xxxx or 0x806f04132582xxxx
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0232
SNMP Trap ID: 50
Automatically notify Support: No
User response:
1. Check the PCI LED.
2. Reseat the affected adapters and riser cards.
3. Update the server firmware (UEFI and IMM) and adapter firmware. Important: Some cluster solutions require
specific code levels or coordinated code updates. If the device is part of a cluster solution, verify that the latest
level of code is supported for the cluster solution before you update the code.
4. Remove both adapters.
Replace the PCIe adapters.
5.
Replace the riser card.
6.
806f0507-0301xxxx [ProcessorElementName] has a Configuration Mismatch. (CPU 1)
Explanation: This message is for the use case when an implementation has detected a Processor Configuration
Mismatch has occurred.
May also be shown as 806f05070301xxxx or 0x806f05070301xxxx
Severity: Error
Alert Category: Critical - CPU
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0062
SNMP Trap ID: 40
Automatically notify Support: No
User response:
1. Check the CPU LED. See more information about the CPU LED in Light path diagnostics.
2. Check for a server firmware update. Important: Some cluster solutions require specific code levels or coordinated
code updates. If the device is part of a cluster solution, verify that the latest level of code is supported for the
cluster solution before you update the code.
3. Make sure that the installed microprocessors are compatible with each other.
4. (Trained technician only) Reseat microprocessor n.
5. (Trained technician only) Replace microprocessor n. (n = microprocessor number)
806f0413-2582xxxx • 806f0507-0301xxxx
Appendix A. Integrated management module II (IMM2) error messages
487