IBM System x3550 M4 Installation And Service Manual page 354

40000001-00000000
CIM Information
SNMP Trap ID
Automatically contact Service
User response
The following is the list of IMM2 error messages and suggested actions to correct
the detected server problems. For more information about IMM2, see the Integrated
Management Module II User's Guide at http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=MIGR-5089484..
40000001-00000000 Management Controller [arg1] Network Initialization Complete.
Explanation: This message is for the use case where a Management Controller network has completed initialization.
May also be shown as 4000000100000000 or 0x4000000100000000
Severity: Info
Alert Category: System - IMM Network event
Serviceable: No
CIM Information: Prefix: IMM and ID: 0001
SNMP Trap ID: 37
Automatically notify Support: No
User response: Information only; no action is required.
336
IBM System x3550 M4 Type 7914: Installation and Service Guide
The prefix of the message ID and the sequence number that is used by the
CIM message registry.
The SNMP trap ID that is found in the SNMP alert management
information base (MIB).
If this field is set to Yes, and you have enabled Electronic Service Agent
(ESA), IBM Support will be notified automatically if the event is generated.
While you wait for IBM Support to call, you can perform the
recommended actions for the event.
The actions that you should perform to solve the event.
Perform the steps listed in this section in the order shown until the
problem is solved. After you perform all of the actions that are described
in this field, if you cannot solve the problem, contact IBM Support.
Note: This list includes error codes and messages that might not apply to
this machine type and model.
™