Smbus To Pci Slots; Bmc Enable/Disable; Sas Enable/Disable (X8Sti Only); Sas Raid Mode Select (X8Sti Only) - Supero SuperServer 5016T-MRB User Manual

S S
UPER ERVER 5016T-MRB/5016T-MR-LN4B User's Manual

SMBus to PCI Slots

2
Jumpers JI C1 and JI
connect the System Management Bus
2
(I C) to the PCI slot. The default set-
ting is Open (Disabled.) Both jumpers
must be set to the same setting (JI
controls the clock and JI
the data). See the table on the right
for jumper settings.

BMC Enable/Disable

The JBMC1 jumper allows the user
to enable or disable the BMC (Base-
board Management Control) chip and
the onboard IPMI connections. This
jumper is to be used together with the
IPMI settings in the BIOS. If this jumper
is set to enabled, please also enable
IPMI in the BIOS and vice versa. The
default position is on pins 1 and 2 to
enable BMC. See the table on the right
for jumper settings.

SAS Enable/Disable (X8STi only)

JPS1 allows you to enable or disable
the SAS controller. The default posi-
tion is on pins 1 and 2 to enable SAS.
See the table on the right for jumper
settings.
SAS RAID Mode Select (X8STi
only)
JPS2 allows you to select the SAS
RAID mode, either Software RAID
or IT Mode. Close this jumper to use
Software RAID (the default setting).
Set this jumper to open to use the
IT Mode.
2
C2 allow you to
2
C1
2 C2 controls
Note: the BMC jumper should be left on pins
1-2 - it is recommended you do not change
this setting.
5-22
SMBus to PCI Slots
2
Jumper Settings (JI C1/JI
Jumper Setting Defi nition
JI 2 C1: Closed JI 2 C2:Closed
2 2
JI C1: Open JI C2: Open
BMC Enable/Disable
Jumper Settings (JBMC1)
Settings Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SAS Enable/Disable
Jumper Settings (JPS1)
Jumper Settings Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SAS RAID Mode Select
Jumper Settings (JPS2)
Settings Defi nition
Close Software RAID Enabled
Open IT Mode Enabled
2
C2)
Enabled
Disabled