Supero SuperServer 5016T-MRB User Manual page 85

Chapter 7: BIOS
PCI/PnP Confi guration
This feature allows the user to set the PCI/PnP confi gurations for the following
items:
Clear NVRAM
This feature clears the NVRAM during system boot. The options are No and
Yes.
Plug & Play OS
Selecting Yes allows the OS to confi gure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select No to
allow the AMI BIOS to confi gure all devices in the system.
PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus. Select
64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96, 128,
160, 192, 224 and 248.
PCI IDE Bus Master
When enabled, the BIOS uses PCI bus mastering for reading/writing to IDE drives.
The options are Disabled and Enabled.
PCIE Width
This feature selects the bus width of the motherboard's PCIE slots. The options are
X8X8X8X8 and X16X8X8.
PCI Slot 1 ~ PCI Slot 4
Use this feature to enable or disable a PCI slot. The options are Disabled and
Enabled.
Load Onboard LAN1 Option ROM, Load Onboard LAN2 Option ROM
This feature is to enable LAN OPROM for PXE. This is to boot computers using a
network interface. The options are Disabled and Enabled.
Load SAS Option ROM (X8STi-3F Only)
This feature is to load the Serial Attached SCSI (SAS) option ROM, if available.
The options are Disabled and Enabled.
7-15