Table of Contents
Advertisement
S
S
UPER
ERVER 5016T-MRB/5016T-MR-LN4B User's Manual
Keyboard/
Mouse Ports
USB Ports
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the motherboard to provide you with system control buttons and
status indicators. These wires have been bundled together in a ribbon cable to
simplify the connection.
Connect the cable from JF1 on the motherboard to the control panel PCB (printed
circuit board). Make sure the red wire plugs into pin 1 on both headers. Pull all
excess cabling out of the airfl ow path. The LEDs inform you of system status. See
Chapter 3 for details on the LEDs and the control panel buttons. Details on JF1
can be found in Chapter 5.
Figure 6-1. Chassis Front View
Figure 6-2. Chassis Rear View
COM1 Port
VGA Port
6-2
Ethernet Ports
Advertisement
Table of Contents
