Table of Contents
Advertisement
S
S
UPER
ERVER 5016T-MTFB User's Manual
SMBus to PCI Slots
2
Jumpers JI
C1 and JI
connect the System Management Bus
2
(I
C) to the PCI slot. The default set-
ting is Open (Disabled.) Both jumpers
must be set to the same setting (JI
controls the clock and JI
the data). See the table on the right
for jumper settings.
BMC Enable/Disable
The JBMC1 jumper allows the user
to enable or disable the BMC (Base-
board Management Control) chip and
the onboard IPMI connections. This
jumper is to be used together with the
IPMI settings in the BIOS. If this jumper
is set to enabled, please also enable
IPMI in the BIOS and vice versa. The
default position is on pins 1 and 2 to
enable BMC. See the table on the right
for jumper settings.
5-11 Onboard Indicators
LAN1/2 LEDs
The Ethernet ports (located beside the
VGA port) have two LEDs. On each
port, one LED indicates activity while
the other LED may be green, amber
or off to indicate the speed of the
connection. See the table on the right
for the indication associated with the
connection speed LED.
2
C2 allow you to
Jumper Setting
JI
2
C1
JI
2
C2 controls
5-22
SMBus to PCI Slots
2
Jumper Settings (JI
C1/JI
Defi nition
2
C1: Closed
JI
2
C2:Closed
2
2
C1: Open
JI
C2: Open
BMC Enable/Disable
Jumper Settings (JBMC1)
Settings
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
Note: the BMC jumper should be left on pins
1-2 - it is recommended you do not change
this setting.
GLAN1/2 LED
(Connection Speed Indicator)
LED Color
Defi nition
Off
NC or 10 Mb/s
Green
100 Mb/s
Amber
1 Gb/s
2
C2)
Enabled
Disabled
Advertisement
Table of Contents
