Vga Enable/Disable; Smbus To Pci Slots; Power Force On; Watch Dog - Supero SUPERSERVER 6014L-M User Manual

VGA Enable/Disable

JPG1 enables or disables the VGA
port on the serverboard. See the table
on the right for jumper settings.

SMBus to PCI Slots

Jumpers J13 and J15 allow you to con-
the
nect PCI-X/PCI slots to the System
.
Management Bus The default setting
is open to disable the connection.
See the table on the right for jumper
settings.

Power Force On

Jumper JPF allows you to enable or
disable the Power Force-On function.
If enabled, power will always stay on
automatically. If disabled (the default
setting), the user must press the power
button to power on the system.

Watch Dog

JWD controls Watch Dog, a system
monitor that takes action when a soft-
ware application freezes the system.
Jumping pins 1-2 will cause WD to
reset the system if an application is
hung up. Jumping pins 2-3 will gen-
erate a non-maskable interrupt signal
for the application that is hung up.
See the table on the right for jumper
settings. Watch Dog can also be
enabled via BIOS.
Note: When enabled, the user needs
to write their own application software
to disable the Watch Dog Timer.
Chapter 5: Advanced Serverboard Setup
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
SMBus to PCI
Jumper Settings (J13, J15)
Jumper Setting
Closed
Open
Power Force-On
Jumper Settings (JPF)
Jumper Setting
Open
Closed
Watch Dog
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
5-19
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Disabled
Force Pwr On
Defi nition
Reset
NMI
Disabled