Drive Bay Installation/Removal; Accessing The Drive Bays - Supero SuperServer 5016T-MRB User Manual

S S
UPER ERVER 5016T-MRB/5016T-MR-LN4B User's Manual
6-4

Drive Bay Installation/Removal

Accessing the Drive Bays

For installing or removing a DVD-ROM or Serial ATA drive, you will need to gain
access to the inside of the 5016T-MRB/5016T-MR-LN4B by removing the top cover
of the chassis. The DVD-ROM drive is an optional component in the server.
SATA Drive Installation
The SATA drive is not hot-swappable, meaning system power must be turned off
before installing or removing.
1. First power down the system and unplug the AC power cord.
2. Remove the top cover of the chassis.
3. Unscrew the retention screw at the corner of the DVD-ROM module and the
four retention screws through the bottom of the chassis. Remove the DVD-
ROM module/drive.
4. Remove the drive tray from the chassis.
5. To add a new SATA drive, install a drive into the tray
board side facing down and so that the mounting holes align with those in the
tray. Secure the drive to the tray with the four screws.
6. Replace the DVD-ROM drive and the top cover when fi nished.
DVD-ROM Drive Installation
The optional DVD-ROM drive must have a "slim" profi le to fi t into the 5016T-
MRB/5016T-MR-LN4B. The drive is installed into a module that fi ts into place in
the chassis.
1. First power down the system and unplug the AC power cord.
2. Remove the top cover of the chassis.
3. Remove the retention screw at the rear right corner of the DVD-ROM module.
4. Remove the DVD-ROM module from the chassis.
5. Attach the side rails and backplane PCB to the DVD-ROM drive (see Figure
6-5.)
with the printed circuit
6-4