Smbus To Pci Slots; Sas Enable/Disable; Sas Raid Mode Select; Power Force On - Supero SUPERSERVER 5015B-M3 User Manual

S S
UPER ERVER 5015B-M3 User's Manual

SMBus to PCI Slots

2
Jumpers JI C1 and JI
connect the System Management Bus
2
(I C) to the PCI-E/PCI slots. The default
setting is Open (Disabled.) Both jumpers
must be set to the same setting (JI
controls the clock and JI
the data). See the table on the right for
jumper settings.

SAS Enable/Disable

JPS1 allows you to enable or disable
SAS ports. The default position is on
pins 1 and 2 to enable SAS. See the
table on the right for jumper settings.

SAS RAID Mode Select

JPS2 allows you to select the SAS RAID
mode: either Software RAID or IT RAID.
Close this jumper to use Software RAID
(default). Set this jumper to open to use the
IT RAID mode. Contact Tech. Support at
Supermicro for more information. See the
table on the right for jumper settings.

Power Force On

Jumper JPF allows you to enable or
disable the Power Force On function. If
enabled, system power will always stay
on. If disabled (the normal setting), the
user needs to press the power button to
power on the system.
2
C2 allow you to
Jumper Setting
JI
2
C1 JI
2
C2 controls
Jumper Settings
Closed
Open*
Note: Contact Supermicro tech support for further
instructions.
5-20
SMBus to PCI Slots
Jumper Settings (JI 2 C1/JI
Defi nition
2 2
C1: Closed JI C2:Closed
2 C1: Open JI 2 C2: Open
SAS Enable/Disable
Jumper Settings (JPS1)
Jumper Settings Defi nition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
SAS RAID Mode Select
Jumper Settings (JPS2)
Defi nition
Enabled (Default)
IT Mode Enabled
Power Force On
Jumper Settings (JPF)
Jumper Setting Defi nition
Closed Force On
Open Disabled
2 C2)
Enabled
Disabled