Table of Contents
Advertisement
Figure 2-6. Installing the Server into a Telco Rack: w/ Rackmount Kit
3.
Next, depress the two buttons on the top of the chassis to release the top
cover while pushing the cover away from you until it stops. You can then lift
the top cover from the chassis to gain full access to the inside of the server.
Checking the Components
1.
You may have one processor already installed into the system board. The
processor should have its own heatsink attached. See Chapter 5 for instruc-
tions on processor installation.
2.
Your system may have come with system memory already installed. Make
sure all DIMMs are fully seated in their slots. For details on adding system
memory, refer to Chapter 5.
3.
If desired, you can install an add-on card to the system. See Chapter 5 for
details on installing a PCI add-on card.
Chapter 2: Server Installation
2-9
Advertisement
Table of Contents
