Simm/Dimm/Rimm Memory Errors - IBM NETVISTA 2251 Hardware Maintenance Manual

SIMM/DIMM/RIMM memory errors

The following SIMM/DIMM/RIMM error messages are issued by the diagnostic
programs.
Note: Y is the SIMM/DIMM/RIMM socket number. Use the System Board Layout
40
Hardware Maintenance Manual
Error
2xx-1y
A memory error was detected in SIMM
socket Y.
2xx-2y
A memory error was detected in
DIMM/RIMM socket Y
Corrupt BIOS
Information in BIOS is not as expected.
Not able to find expected DMI information
from BIOS.
Memory controller chipset vendor ID does
not match expected value.
Test aborted by user
section in the latest Hardware Maintenance Manual (HMM) to reference the
memory sockets.
FRU/Action
Replace the SIMM in the socket identified by
the last digit of the error code.
Re-run the test.
If the same error code occurs again, replace
the system board.
Replace the DIMM/RIMM in the socket
identified by the last digit of the error code.
Re-run the test.
If the same error code occurs again, replace
the system board or where memory is on
the processor card, replace the processor
card.
Reflash the BIOS.
Perform boot block recovery.
Replace the system board.
Restart test.