Star Trac SPINNER BLADE ION Installation & Owner's Manual page 37

Stage Function
Summary Screen
SPINNER BLADE ION MANUFACTURED by STAR TRAC - OWNER'S MANUAL |
®
The Spinner Blade ION computer Stage Function allows the
rider to mark and measure data for timed intervals.
START a new timed interval by pressing and holding the
RESET button for two seconds.
• The ride/stage timer on LINE 4 in the second screen and
third screen will reset to 0.
• Below the reset time an "s" will flash, indicating that the
computer is timing an interval.
STOP the timed interval by, pressing and holding the RESET
button again for two seconds.
• The timer will stop timing, and the "s" at the bottom of the
display will stop flashing.
• To reset back to 0, press and hold the RESET button
again for two seconds.
NOTE: Resetting the stage timer will also reset the data
displayed on the averages screen, i.e. average power and
average cadence shown will be averages for the stage, not the
entire ride.
Upon completion of the ride or when the rider stops
pedaling, the ION computer will remain powered for its
default time of 30 seconds, unless this time has been
adjusted in the maintenance mode. If the backlight was
illuminated, it will turn off. The power for this time is being
supplied by the computer's internal rechargeable battery
During this time, the computer will show a Summary
Screen. The Summary Screens display is as follows:
LINE 2: Average cadence for the ride in RPM
LINE 3: Flashes between average power and peak
power (or maximum power in watts) for the ride /
stage.
LINE 4: Total ride / stage time
NOTE: If the rider resumes pedaling while the computer is
still on and in Summary mode, the computer will resume
timing the ride / stage where it was left off and will continue
recording data.
37