Star Trac SPINNER BLADE ION Installation & Owner's Manual page 24

33.
Insert the "Pull Out Prevent" clip into the oval plastic
cover (Fig. 33).
34.
Locate the set of pedals along with the corresponding
hardware (Fig. 34).
35.
Insert each pedal into their corresponding crank
(Fig. 35 A).
NOTE: Each pedal is marked with an indentation of the
letters "L" (LEFT) or "R" (RIGHT) towards the corner of
the surface where the SPD clips are located (Fig. 35 B).
24 | SPINNER BLADE ION MANUFACTURED by STAR TRAC - OWNER'S MANUAL
Fig. 33
Fig. 34
Fig. 35A
Fig. 35B