Configuring Ptz Limit Stops - HIKVISION DS-2DF7284-AW User Manual

User Manual of IR Network Speed Dome
 Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds,
10 seconds, Always Close or Always Open.
 PT Status: Set the azimuth angle display duration while panning and tilting as
2 seconds, 5 seconds, 10 seconds, Always Close or Always Open.
 Preset Status: Set the preset name display duration while calling the preset as
2 seconds, 5 seconds, 10 seconds, Always Close or Always Open.
Power-off Memory: The dome can resume its previous PTZ status or actions after

it restarted from a power-off. You can set the time point of which the dome
resumes its PTZ status. You can set it to resume the status of 30 seconds, 60
seconds, 300 seconds or 600 seconds before power-off.
3. Click

5.3 Configuring PTZ Limit Stops

Purpose:
The dome can be programmed to move within the configurable limit stops (left/right,
up/down).
Steps:
1. Enter the Limit Configuration interface:
Configuration > Advanced Configuration > PTZ > Limit
2. Click the checkbox of Enable Limit and choose the limit type as manual stops or
scan stops.
 Manual Stops:
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
to save the settings.
Figure 5-3 Configure the PTZ Limit
34
www.cctvireland.ie