Setting The Network Speed Dome Over The Wan; Static Ip Connection - HIKVISION DS-2DF7284-AW User Manual

User Manual of IR Network Speed Dome

2.2 Setting the Network Speed Dome over the WAN

Purpose:
This section explains how to connect the network speed dome to the WAN with a
static IP or a dynamic IP.

2.2.1 Static IP Connection

Before you start:
Please apply a static IP from an ISP (Internet Service Provider). With the static IP
address, you can connect the network speed dome via a router or connect it to the
WAN directly.
Connecting the network speed dome via a router

Steps:
1. Connect the network speed dome to the router.
2. Assign a LAN IP address, the subnet mask and the gateway. Refer to Section 2.1.2
Detecting and Changing the IP Address for detailed IP address configuration of
the speed dome.
3. Save the static IP in the router.
4. Set port mapping, E.g., 80, 8000 and 554 ports. The steps for port mapping vary
depending on different routers. Please call the router manufacturer for assistance
with port mapping.
Note: Refer to Appendix 2 for detailed information about port mapping.
5. Visit the network speed dome through a web browser or the client software over
the internet.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Figure 2-3 SADP Interface
13
www.cctvireland.ie